Rev: 04.08.19
Page 3
CCD-0002107
Preparation
Initializing the System
1. To initialize the remote, press buttons 5 and 6 — the Down and Up buttons (Fig. 1) — at the same
time. The status indicator light on the remote will turn green.
2. Press the ACC. IN and ACC. OUT buttons (Fig. 1) simultaneously to activate the receiver.
NOTE: If the status indicator light on the remote does not light, open the remote by removing the six
screws on the back. Replace the AA battery or plug in the coiled cord between the remote and the
receiver to operate in corded mode.
Button
Description
1
Up Arrow - Extends left front jack.
2
Up Arrow - Extends right front jack.
3
Down Arrow - Retracts left front jack.
4
Down Arrow - Retracts right front jack.
5
All Down - All four jacks retract.
6
All Up - All four jacks extend.
7
Up Arrow - Extends left rear jack.
8
Up Arrow - Extends right rear jack.
9
Down Arrow - Retracts left rear jack.
0
Down Arrow - Retracts right rear jack.
Fig. 1
Button
Description
ACC.
Auxiliary control for room slide or
other motorized auxiliary device.
Receiver
status
indicator
No light - No power to receiver from
12V DC supply or ground failure.
Red light - Insufficient power for
proper operation.
Orange light - Receiver operational
but in idle mode (See Idle Time Out).
Green light - Receiver in operational
mode.
ACC. IN,
OUT
Reset receiver by pressing both ACC.
buttons simultaneously.
All Up,
All Down
Reset remote by pressing both All Up
and All Down buttons simultaneously.
ACC. Buttons
All Up
All Down
Status
Indicator
Red Buttons: Raise camper (jacks extend)
Blue Buttons: Lower camper (jacks retract)
