LCEQ LHD-12, User Manual

Page: 5 / 8

3
temperature on the temperature meter. The error is
±
3
℃
.
Notes: When setting temperature, please refer to the drying temperature of plastic material. If temperature is
too high, the material on the shade separator will agglomerate, which will cause machine failure. The actual
experience will help you proper adjustment on temperature. Over-heat protector is added to prevent pipe
heater from being burned.
Drying Temperature Table of Plastic Materials
6. Temperature Controller
Note: Parameter have been all set before ex-factory, so there is no need to change it. If set error occur unintentionally, can
reset to factory setting.
Raw material Dry temp. Dry time
ABS AS 80
℃
176
℉
2.5H
PE PP 90
℃
194
℉
1H
PU 90
℃
194
℉
2.5H
PA 75
℃
167
℉
5H
PC 120
℃
248
℉
2.5H
PPT 130
℃
266
℉
2.5H