Network HDD Recorder User Manual
48
4.
Select
Infrastructure (AP)
and press the
navigation button. The
Get
SSID Name
screen displays.
5.
Select
Auto
to scan for available
Service Set Identifiers
(SSIDs). A list of
available SSIDs displays, showing security method and signal strength.
6.
Select the desired SSID from the list and press the
navigation button.
The
Confirm SSID Name
screen displays.
Press the
navigation button to confirm the SSID. The
WLAN Security
screen displays. The Network HDD Recorder supports an
Open System
connection (not recommended) and
WEP
and
WPA
secure connections.
7.
You must select the security method supported by the target SSID
or the connection will fail.
8.
Select the
Wireless Security
method used by the target SSID and press the
navigation button. A confirmation screen displays.
9.
Press the
navigation button to proceed.
If your SSID does not use security features, the
Wireless Address Setup
screen displays. Select the connection method and follow the onscreen
prompts to test and complete the connection, OR
If your SSID uses security features, select WEP or WPA and enter the
security key specified by the SSID. Select the connection method and
follow the onscreen prompts to test and complete the connection.
A successful connection is established when an IP address is displayed
and the signal strength monitor shows a positive signal.
10.
Connection time may vary depending on network traffic and
connection speeds.
See your Wireless AP User Manual for more information on
Wireless networks.
