LC Packings Probot 161403, User Manual

Page: 94 / 118

Appendix B
B-6
D960R3
User’s Manual Probot
Follow the steps a) – g) as discussed above except that you define one waste
position rather than a group. The ‘Type’ must be ‘Reagent’.
FIGURE B-8 The Group Editor
B.4 Electrical Connections
To control the TTL inputs of the Probot (Section 2.4.1 D) by the relay outputs of
the UltiMate Micropump:
a) Connect the event output 3 (Open Collector 1) to the Probot START input as
presented in TABLE B-1.
b) Connect the event output 7 (relay 1) to the Probot TTL 1 (‘Peak start’) input
as presented in TABLE B-1.
c) Connect the event output 8 (relay 2) to the Probot TTL 2 (‘Peak end’) input
as presented in TABLE B-1.
TABLE B-1 Connecting the Probot and the Micropump
Probot Color Code UltiMate Micropump EVENTS
Start Signal
Start
Lilac
Event 3, pin 3
Ground
Black
Ground, pin 4
TTL Inputs (TT1=Peak Start, TTL2=Peak End)
TTL1, pin 1
Red
Event 7, pin 7
TTL2, pin 3
Orange
Event 8, pin 9
Ground, pins 9,11,13,15
Blue
Event 7 and 8, pins 8, 10
B.5 Listing of the CHROMELEON Program used for this Example
Pressure.LowerLimit = 0.0
Pressure.UpperLimit = 400.0
%A.Equate = "%A"
%B.Equate = "%B"
%C.Equate = "%C"
%D.Equate = "%D"
CRP = 104.2
ParkPercentage = Disabled