S1 Dream-T Espresso Machine
Owner’s Manual
Page 3
First Time Set Up - Filling the coffee boiler
Plug the machine into the electrical outlet, but do NOT turn it on. A GFI outlet is
recommended to better protect the machine, but is not necessary.
With the machine turned off press and hold the
button for approximately 5 seconds. The display will
then show the message shown to the right.
Press either the single or double shot button to start
filling the coffee boiler.
When done filling the coffee boiler then press the
to return to standby mode.
After filling the coffee boiler then refill the water reservoir before turning the machine on
so there will enough water to fill the steam boiler.
Turning the machine on for the first time
Press and hold the
button for approximately 3 seconds until the display lights up. The
pump will come on to start filling the steam boiler and will turn off once it is filled.
After the pump has turned off from filling the steam boiler then press the
button for
approximately 15 seconds until you have water flowing from the grouphead and then
press the button again to stop the flow.
Whichever portafilter you intend to use then lock it into the grouphead so it will warm up
with the machine.
If you plan on using the steam boiler for steaming milk then press the
button.
Allow the machine to heat up for at least 30 minutes for optimal performance and
temperature stability. It is very important to keep the portafilter in the grouphead and
also keep the cups on the cup warming tray. Failure to do so will result in a cold and
sour shot.
Set the grind particle size on your grinder. This is very important to achieve good
results. Set the grind so that a 2oz double shot comes out in about 25 seconds.
The grind should be finer than salt, but coarser than powder.
