owner’s manual /
ENG
5/
Calibration
6/
And off you go
4/
Installation
1/ You go to a wind tunnel or training centre to calibrate
the device
2/ You switch the device on with the on/off button
(picture 1)
3/ You position yourself on your own bike in your most optimal
aerodynamic position
(picture 6B)
4/ You hold this position for at least five minutes, preferably
while pedaling, to verify if this position is biomechanically
desirable
5/ Your trainer presses the calibration button for 2-3 seconds
(picture 1)
6/ You switch the device off, the setting is stored
PC:
Compatible for Windows Vista, Windows 7 and Windows 8
Requirements: USB port, Microsoft .NET 4.0
MAC:
Compatible for MAC OSX 10.10 (Yosemite) and higher
Requirements: USB port
1/ You
connect
your Inclination Sensor to a PC or MAC
with a
USB cable
2/ The monitor is recognized as a
mass storage device/
USB memory stick
3/ Go to
www.lazersport.com/inclination_sensor#soft-
ware
and download the software (PC or Mac). You can put
this file onto a computer hard drive location, for example
your desktop
4/ You select the tab
“personal settings”
A/ Choose your helmet: Tardiz or Wasp Air
B/ Choose the deviation (in degrees) after which
a feedback is given as compared to your optimal
posture
C/ Choose the type of feedback that you prefer:
auditory, tactile or both
D/ Enable or disable the calibration button during
the use of the sensor
5/ You select the tab
“Calibrations”
A/ You can save a calibration
B/ You can load a calibration
Good job!
Bad position
The Inclination Sensor gives you a tactile and/or acoustic
feedback when you are out of your aerodynamic cycling pos-
ture. The tactile and/or acoustic feedback is intensified when
you are more out of position and reduces when you go back
to a more optimal position.
The Inclination Sensor allows you to focus on your perfor-
mance when you remain in your aerodynamic cycling posture.
B
A
7/
Daily use
1/ Use the device whenever you feel like training. Calibration
for daily use is not required, a one-time calibration in the
wind-tunnel or by your trainer or dealer should be good for
two or three months if not longer
2/ Battery life-time is between six and eight hours if the device
is continuously giving feedback
3/ Recharge battery using the USB cable using a standard
USB connection on a PC or using a double isolated / SELV
type charger
4/ Store the sensor in a dry room between 15°C and 25°C
5/ Do NOT use Inclination Sensor during rain or snow fall
6/ Do NOT use Inclination Sensor in mountains
7/ For cleaning it is advised to not use any aggressive
chemical cleaning agents, simple moisture cloth is advised.
Do not submerge the sensor for cleaning
8/ When your PC or MAC does not recognize the Inclination
Sensor after 30 seconds, please unplug it and try again
WARNING
∙ This product contains a Li-ion or Li-ion polymer battery.
There is a risk of fire or burns if the battery is handled
improperly. Do not attempt to open or service the
product.
∙ Do not dissemble, crush, puncture, short contacts or
circuits, dispose of in fire or water, or expose battery /
sensor to temperatures higher than 60°C (140°F)
inclination sensor
