Page 4 of 4
Step 2:
Attach the back (D) to the right arm(A)
and left arm(B) with M6x 32mm Allen head
bolt(F) and M6 washer(G) by Allen wrench(H).
Note: Check alignment and now tighten all
the bolts.
See Figure 2
Step 1
：
Put the left arm (B) on a soft, non-abrasive
surface carefully. Attach the seat(C) to the left arm (B)
with M6x 32mm Allen head bolt (F) and M6x 15mm Allen
head bolt (E) and M6 washer(G) by Allen wrench(H).
Repeat the same procedure on the right arm (A).
Note: Do not fully tighten at this point.
See Figure 1
Figure 1
Step
3:
Place the seat cushion (I) on the seat,
tie the back cushion (J) to the back, and put
Pillow (k) on seat cushion.
Now your chair is ready to use!
See Figure 3
Figure 2
Figure 3
