Page 4 of 5
A
Step 1
：
Attach the seat (C) to the left arm (A) with
M6x 40mm Allen head bolt (O) and M6 Washer
(N) by L wrench (Q). Repeat the same procedure
on the right arm (B).
Note:
Do not fully tighten at this point
.
See figure 1
Figure 3
Figure 2
Step 3:
Place the chair seat (C) with assembled
arms and back upside down on a flat surface.
Attach stem bracket (H) to the chair seat (C) with
M8x35mm hex head bolt (L),steel plate (I),spring
washer (J) and nut (K) then tighten hex head bolt
(L) fully with open wrench (M) as shown on
Figure 3. Cover the M8 bolts with M8 PE cap (S).
Note:
Before assembling stem bracket to chair
seat, please
make sure chair frame and stem
bracket will face the same direction as shown
by the arrow label on stem bracket and seat.
And please refer to above expanded view for
correct assembly.
See Figure 3
Step 2
：
Attach the Back (D) to the right arm (B)
and left arm (A) with M6x 15mm Allen head bolt
(P) and M6 washer (N) by L wrench (Q).
Note: Check alignment and now tighten all the
M6 bolts. Cover the M6 bolts with M6 PE cap
(R).
See figure 2
Figure 1
