20
Preliminary
Operating Instructions
For Optional Wireless Remote
To Use the Do Not Disturb:
Turning on the Do Not Disturb feature blocks the furniture’s communication with the remote. When the remote is
blocked, the only features available for use are those with commands, or buttons on the cradle—these are the
Memory I, Memory II, Home and Find Me features.
Slide the Do Not Disturb button to the left (facing) position to turn on the feature and block out all commands
coming from the remote, allowing only the commands activated by a button press on the cradle. Slide the button
to the right position to turn off the feature and unblock the remote, allowing communication between the furniture
and remote.
To Use the Find Me:
Use this feature to locate a misplaced or lost remote.
Press and release the Find Me button on the cradle to send a signal to the remote. When the signal reaches the
remote, the remote LED lights start flashing and a loud tone plays continuously from the remote for two minutes,
or until any key is pressed on the remote. A key press on the remote when in Find Me mode does not produce
any movement, it only clears the Find Me response.
You can also clear the Find Me mode by pressing the Find Me button a second time, within two minutes of the
first press.
The Find Me mode is always enabled and works regardless if the Do Not Disturb feature is turned on or off. Find
Me mode is also enabled when the furniture is operating on the 9-volt battery back-up in the power supply, or
the
optional
rechargeable lithium-ion battery pack
.
NOTE: For the Find Me feature to operate, the furniture must be powered, working batteries properly installed in
the remote and the remote within range of the furniture.
To Use the USB Charging Port:
Plug the USB cable of a small portable electronic device into the USB charging port. Unplug the USB cable from the
charging port when charging is complete.
The USB port is for charging only and does not save or transfer data.
NOTE: When the furniture is operating on the 9-volt battery back-up in the power supply, the USB charge port is
disabled. W
hen the furniture is powered by the
optional
rechargeable lithium-ion battery pack, the USB port
is enabled, as long as there is adequate charge.
