POWER CORE User Manual
Version: V6.0.0/5
234/459
14. Snapshots System
14.6.2 Logout
You can also use the 'Login' window, to "log out". This will leave the console in a default or safe state, as defined
by the console configuration.
1
.
Re-open the
Current User
is displayed:
2
.
Select
Logout
.
The console may reset, for example to a safe (blank) state.
The logout state is controlled by the Administrator settings for the user called "Nobody". Therefore, it is the
login snapshot for the user "Nobody" which resets the console to a blank state, and the user rights for
"Nobody" which prevent access to console operation.
To change this behaviour, you must login as an Administrator and edit the login snapshot and user rights for
the user "Nobody" in the usual manner. See the
14.6.3 Changing Your Password
Once you are logged in, you may change your password as follows:
1
.
Re-open the
You should see that you are logged in as the Current User:
You cannot change your password if you are not logged in!
If you have forgotten your password, then an Administrator can reset it to
0000
. Administrators, please see
There are no restrictions on the characters used for a password.
2
.
Select
Change Password
.
3
.
Enter your new password into both the
Password
and
Repeat
fields, and select
OK
:
4
.
Test the new password by
.
