LAWO mc256 MKII, Technical Manual

Page: 367 / 372

mc²56 MKII Technical Manual V5.10.2/1 367
Chapter 7: Appendices
Lawo Default TCP/IP Addresses
Lawo Default TCP/IP Addresses
Default IP Addresses
The default IP addresses, for different Lawo product control systems, are:
·
mc
2
36 = 192.168.102.36
·
mc
2
56 = 192.168.102.56
·
mc
2
66 = 192.168.102.65
·
Nova73 (HD & Compact) = 192.168.102.1
·
mc
2
Micro Core = 192.168.102.136
·
Nova37 = 192.168.102.137
·
mxGUI (local control system) = 192.168.56.101
You can check the IP address of your control system from the GUI (by selecting System from the tree on the left-
hand side of the Signal Settings display).
Subnet Mask
For all products, the default Subnet Mask is 255.255.255.0 .
Other IP Addresses
The table below lists the other IP addresses used within a mc²56 MKII installation:
Device Port IP Address Notes
Router Module Slot A ETHERNET A 192.168.105.1 Fixed address.
Router Module Slot A ETHERNET B 192.168.102.xxx Default address of the control system
(as listed above).
Router Module Slot B
(optional) ETHERNET A 192.168.106.1 Fixed address.
Router Module Slot B
(optional) ETHERNET B 192.168.102.xxx This address is always one digit higher
than that of the main control system.
Ethernet Switch (optional) - 192.168.102.250 Default address.
ISDN Dialup Router
(optional) - 192.168.102.200 Default address.
We recommend keeping the default IP addresses, where possible, as this will simplify remote maintenance.
The control system address (ETHERNET B) can be changed in a file called "ip-address" located on the data
card (in the
/data/config folder).