mc²56 MKII Technical Manual
V5.10.2/1
364
Chapter 7: Appendices
SDI Parameters
SDI Outputs
Select an SDI output signal from the
System
tree, and click on
SDI
to adjust the following parameters:
·
Group select
– this field defines which pair of SDI channels will map to the selected SDI card output. In
our example,
Group 1 Channels 1&2
from the SDI stream will be embedded to
SDI Signal Out 1
and
2
.
The assignment is only active if the SDI card
Embedder mode
is set to
On
or
Clean
.
·
Delay time
&
Delay
– check the
Delay
option to enable delay for the stereo output, and set the delay
time in ms.
Delay is only applied to SDI outputs if the SDI card
Delay
parameter is set to
Embedder
.
·
Wordlength
– choose from the available drop-down menu options.
When 16 or 20-bit are selected, dither is automatically applied.
Summary of Contents for mc256 MKII
Page 1: ...Technical Manual mc 56 MKII Version 5 10 2 1 Edition 12 September 2017...
Page 350: ...mc 56 MKII Technical Manual V5 10 2 1 350 Chapter 7 Appendices Local I O Wiring...
Page 351: ...mc 56 MKII Technical Manual V5 10 2 1 351 Chapter 7 Appendices Local I O Wiring...
Page 352: ...mc 56 MKII Technical Manual V5 10 2 1 352 Chapter 7 Appendices Local I O Wiring...