mc²56 MKII Technical Manual
V5.10.2/1
252
Chapter 4: Service/Maintenance
File Transfer via FTP
File Transfer via FTP
All files stored on the control system can be accessed by a suitable FTP client.
You will need this tool to transfer files, such as system software or factory configuration (.tcl) files, which are
"hidden" from normal console GUI, mxGUI and AdminHD operation.
Warning
File transfer via FTP will make low level changes to your system. Therefore, these procedures should
only
be
performed by a fully trained member of staff.
To perform a file transfer:
1.
Install a suitable FTP client on your computer. We recommend using
Filezilla
, a free FTP client for all
platforms, which can be downloaded from
2.
Connect your computer to the
.
3.
Configure the
on your computer's network interface card.
4.
Open the
Filezilla
FTP client, and enter the following information:
·
Host = the
of your control system
·
Username =
root
·
Password =
hong
Default IP address of mc
2
56 shown:
5.
Click on
Quickconnect
to make the connection.
The session opens, and you will see the filing system of the control system on the right (under
Remote Site
):
Summary of Contents for mc256 MKII
Page 1: ...Technical Manual mc 56 MKII Version 5 10 2 1 Edition 12 September 2017...
Page 350: ...mc 56 MKII Technical Manual V5 10 2 1 350 Chapter 7 Appendices Local I O Wiring...
Page 351: ...mc 56 MKII Technical Manual V5 10 2 1 351 Chapter 7 Appendices Local I O Wiring...
Page 352: ...mc 56 MKII Technical Manual V5 10 2 1 352 Chapter 7 Appendices Local I O Wiring...
