LawnMaster NPTGSS2617A, Operator'S Manual

Page: 14 / 80

BATTERY PACK AND CHARGER
INDICATOR LIGHTS STATUS
Green, continuous
Fully charged / Connected to
power supply (Standby)
Red, continuous Charging
If any part of the charger is missing or damaged, do not operate it! Replace the charger with a new
one. Failure to heed this warning could result in possible serious injury.
Check the voltage! The
voltage must comply with the information on the rating label.
BATTERY CHARGING
■ Use only with 8.4V LawnMaster
®
YLS0042-T084045 battery charger. The battery charger
supplied is specifically designed for the lithium-ion battery used in this tool.
■ Check the power voltage! Battery chargers operate on 100-240V AC.
■ Charge the battery between 40°F (4°C) and 100°F (38°C) to ensure an optimum battery service
life.
■ Protect the battery from heat, from continuous exposure to sun, and keep away from radiation
or other heat sources. Do not leave the battery in the tool in direct sunlight over long periods.
■ The battery is supplied uncharged. Fully charge the battery before using the tool for the first
time. The lithium-ion battery can be charged at any time without reducing its service life.
Interrupting the charging procedure does not affect the battery.
CHARGER LEDS
■ If the battery is not connected to the charger, a continuous green LED light indicates that the
plug is plugged into an outlet socket and the battery charger is ready for operation.
■ Charging: a continuous red LED on the charger indicates that the battery is charging normally.
■ Charged: a continuous green LED on the charger indicates that the battery is ready for use.
■ After continuous or repeated charging cycles without interruption, the charger may warm up.
This is normal and does not indicate a technical defect of the battery charger.
CHARGING THE BATTERY PACK
(See Figs. 7-8)
■ Insert the charging connector into the charging port on the battery (Fig. 7).
■ Connect the charger to the power supply.
■ Allow sufficient charging time (see Product Specifications), and then disconnect the charger from
the power supply.
■ Remove the charging connector from the charging port (Fig. 8).
14