LawnMaster MEB1014M, Operator'S Manual

Page: 21 / 50

21
TROUBLESHOOTING
Problem Possible Cause Solution
Carriage bolts not seated properly.
Handle locks not tightened.
Adjust the height of the handle
and make sure the carriage bolts
are seated properly.
Tighten Handle locks.
Extension cord not connected to
the mower plug.
Extension cord not connected to
power source.
Tripped circuit breaker in the house.
Motor control switch defective.
Reconnect the cord and use the
cord retainer to keep the cord
close to the motor/blade control.
Connect the extension cord to a
live 120V AC, 60 Hz AC receptacle.
Reset house circuit breaker.
If it trips again, call a qualified
electrician.
Have motor control switch replaced
by an authorized service center.
Lawn is rough or uneven or
cutting height not set properly.
Move the wheels to a higher posi-
tion. All wheels must be placed in
the same cutting height for the
mower to cut evenly.
Handle not in position.
Mower will not
operate
Mower cutting grass
unevenly.
Wet grass clippings sticking to
the underside of the deck.
Wait until the grass dries before
mowing.
Mower not mulching
properly.
High grass, rear of mower housing
and blade dragging in heavy grass,
or cutting height too low.
Raise cutting height. Mower hard to push.
Blade is unbalanced.
Bent motor shaft.
Balance the blade by grinding
each cutting edge equally.
Stop the motor, disconnect the
power source, and inspect for
damage. Have repaired made
by an authorized service center
before restarting.
Mower vibrating at
higher speed