A STEELFORT PRODUCT
15
SERVICE AND ADJUSTMENTS
1.
Release drive control bar to stop the lawn
mower.
2.
Make sure the blade and all moving parts have
stopped completely.
3.
Disconnect cable from the spark-plug and place
where it cannot come in contact with plug.
4.
Make sure that all the nuts, bolts and screws are
tightened and the device in a safe condition.
5.
Let the mower to cool before using it in a closed
area off.
6.
In order to avoid the risk of fire, keep motor
housing and ventilation openings free of grass,
leaves and oil or fat.
7.
Replace worn out or damaged parts for security
reasons.
LAWNMOWER
TO ADJUST HANDLE
The handle on your lawn mower has different
height positions-adjust to height that suits you.
1.
Loosen the 2 lever A on both sides.
2.
Rotate upper handle to new catch desired.
3.
Re-tighten lever A.
REAR DEFLECTOR
The rear deflector, attached between the rear wheels
of your mower, is provided to minimize the possibility
that objects will be thrown out of the rear of the
mower into the operator’s mowing position. If the
deflector becomes damaged, it should be replaced.
ENGINE
ENGINE SPEED
Your engine speed has been factory set. Do not
attempt to increase engine speed or it may result
in personal injury. If you believe that the engine is
running too fast or too slow, take your lawn mower
to your local LawnMaster dealer for repair and
adjustment.
THROTTLE CONTROL
If it becomes necessary to adjust or replace the
throttle control, see the adjustment section of your
engine manual.
CARBURETTOR
The carburettor has been preset at the factory and
adjustment should not be necessary. However, minor
adjustment may be required to compensate for
differences in fuel, temperature, altitude or load.
•
The air filter must be assembled to the
carburettor when running engine - never run an
engine without an air-filter.
•
Best carburettor adjustment is obtained when
fuel tank is 1/4 full.
