LawnMaster CLMF4841E, Instruction Manual

Page: 23 / 36

23
OPERATION
The blade may keep rotating for a few seconds after the device has been switched off. Do not
touch the rotating blade. A rotating blade can cause injury.
WARNING
■ To switch on, insert the isolator key located within the battery compartment. Press and hold the
safety switch button and gently pull the start/stop switch lever towards the upper handle (Fig. 14
& 15). Once started, release the safety switch button.
■ To power off the mower, release the start/stop switch lever.
■ Remove the isolator key if the mower is not going to be used immediately.
iPower Mode Indicator (See Fig. 16)
Push the press button repeatedly to cycle through the different motor power output levels (Fig. 16).
By default, the mower power is set to “AUTO”.
iPower Battery Indicator (See Fig. 16)
■ Push the press button to check on the battery status.
■ The number of lights lit will depend on the condition of the battery.
■ 4 lights indicate a fully charged battery, 1 light indicates the battery needs to be charged
(Fig. 16).
If the temperature range is correct and flashing red LED light continues, then remove and reinstall
the battery pack. If the LED status repeats a second time, try to charge another identical battery.
If the battery charges normally, dispose of the defective battery pack (see Recycling and Disposal
section).
If the flashing red light continues after installing the second battery (ensure the battery temperature
is normal), the charger may be defective. Replace with a new one.
After continuous or repeated charging cycles without interruption, the charger may warm up. This
is normal and does not indicate a technical defect of the battery charger.
Starting/Stopping the Mower (See Figs. 14-15)
Mode Indicator on Panel
AUT
O
1
2
3
Motor Power Output Level
Automatically adjust to suit your lawn conditions.
Lawn needs only light mowing.
Mow taller and thicker grass.
Maximum motor power output, mow the most
stubborn grass.
Runtime
Balanced Runtime
Maximum Runtime
Medium Runtime
Minimum Runtime