18
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Blower will not start when
power switch is depressed.
The battery is not secure.
To secure the battery pack,
Make sure the latches on the
bottom of the battery pack snap
into place.
The battery is not charged.
Charge the battery pack
according to the instructions in
the instruction manual.
The battery is defective.
Replace with a new, charged
battery.
Defective power switch.
Contact the After Sales
Helpline.
Blower will not blow.
The tube is blocked.
Remove battery and clear
debris from in and around tube.
No charging procedure
possible.
The battery contacts are
contaminated.
Clean the battery contacts (e.g.
by inserting and removing the
battery several times) or replace
the battery.
Socket outlet, fuse, mains cable
or battery charger are defective.
Check the mains voltage and
fuse, if necessary have the
battery charger checked by an
authorised customer service
station.
The battery has a fault.
Contact the After Sales
Helpline.
ONLY PERFORM THE STEPS DESCRIBED WITHIN THESE INSTRUCTIONS!
REMOVE THE BATTERY PACK BEFORE TROUBLESHOOTING.
WARNING
WARNING
Summary of Contents for CLHT2452-01
