25
OPERATION
■ The correct chain tension is achieved when the saw chain can be lifted by approx. 2-4mm from
the guide bar in the centre (Fig. 11).
■ Turn the locking knob to tighten the chain cover completely.
Filling the Oil Tank
(See Fig. 12)
NOTE:
Check the oil fill level regularly. It is recommended to use LawnMaster
®
bio-oil. If you have
no LawnMaster
®
bio-oil available, use chain lubrication oil with low adhesive additive content.
■ Place the product on a level surface.
■ Clean the area around the oil tank cap. Unscrew and open the oil tank cap and fill up with chain
oil (Fig. 12).
NOTE:
Ensure the chain oil level is always above the “MIN” mark during operation.
■ Wipe off any spilled oil with a soft cloth and refit the chain oil tank cap.
NOTE:
Always dispose of lubricant, used oil and objects contaminated with them in accordance with
local regulations.
Starting/Stopping the Chain Saw
(See Figs. 13-14)
The product is not filled with chain oil. It is essential to fill the product with chain oil before using it!
Never operate the product without chain oil, as this will result in extensive damage to the product!
WARNING
Always switch off the chain saw and allow the motor to cool before filling with chain oil. There is a
risk of fire if oil overflows.
WARNING
Switch on the chain saw only when guide bar, saw chain and chain cover are correctly assembled.
Make sure you have a secure stance. Before starting, ensure that the chain saw is in contact with
no objects.
WARNING
Summary of Contents for CLCS2425-01
Page 2: ......
Page 37: ......
Page 38: ...Fig 3 Fig 4 Fig 5 Fig 6 Fig 1 Fig 2 Fig 8 Fig 7 Fig 9 Fig 10 ...
