A STEELFORT PRODUCT
13
CHANGE / CLEAN SPARK PLUG
•
Periodically remove and clean the spark plug
using a metal brush to get rid of any deposits.
•
Check and reset the correct distance between
the electrodes.
•
Replace the spark plug and fasten it firmly
using the supplied wrench.
•
The spark plug must be replaced with one
with the same characteristics whenever the
electrodes have burnt or the insulation has
worn, and in any case every 100 working hours.
STARTING UNIT
To avoid overheating and damage to the engine,
always keep the cooling air vents clean and free of
sawdust and debris. If you notice signs of wear on the
starter cable, contact your Local LawnMaster Dealer
for a replacement.
NUTS & SCREWS
Periodically check that all the nuts and screws are
securely tightened and the hand grips are
tightly fastened.
ORDERING REPLACEMENT PARTS
Please quote the following data when ordering
replacement parts:
• Type of machine
• Article number of the machine
• Identification number of the machine
• Replacement part number of the part required
STORAGE
At the end of each working session, carefully clean
the machine of dust and debris, and make sure
that there are no damaged parts, replacing any faulty
parts. The machine must be stored in a dry
place away from the elements and with the cover
correctly fitted.
SHARPENING THE LINE CUTTING KNIFE
•
Remove the line cutting knife (A) from the guard
(B) by unscrewing the screws (C).
•
Fix the line cutting knife in a vice and sharpen
it using a flat file, being careful to retain the
original cutting angle.
•
Refit the knife on the guard.
DISPOSAL AND RECYCLING
The unit is supplied in packaging to prevent it being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system. The unit is made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your LawnMaster dealer or your
local council for guidance.
