7
Unfolding the Handle
1. Cut the tie that secures the control cable to the handle.
2. Loosen the knobs and pull out the handle locks until
the upper handle rotates freely (Fig. 3).
3. Position the upper handle as shown in Figure 2.
m4522
1
Figure 2
1.
Upper handle
Note: Make sure that the cable guide is in the position as
shown in Figure 3.
m4523
1
2
3
Figure 3
1.
Knob
2.
Cable guide
3.
Handle lock
4. Install the control cable to the control bar.
Model 28225
Squeeze the control bar together and remove it from
the handle. Insert the loose end of the control cable
into the bottom hole of the control bar as illustrated in
Figure 4, and squeeze the control bar and insert it into
the handle.
1
2
5
4
m-5533/m-2708
1
2
3
6
4
Figure 4
1.
Top hole
2.
Bottom hole
3.
1/16 to 1/8 inch (2 to
3 mm) gap
4.
Control bar
5.
Spring cover
6.
Control cable
5. Fully insert the handle locks.
6. Tighten the knobs until they are snug.
7. Ensure that a 1/16 to 1/8 inch (2 to 3 mm) gap exists
between the control bar and the handle (Refer to
Adjusting the Control Cable on page 12).
Model 28226
1. Insert the loose end of the control cable into the
bottom hole of the control bar as illustrated in
Figure 5.
m-5519
4
3
2
1
5
Figure 5
1.
Cable
2.
Control bar
3.
Top hole
4.
Bottom hole
5.
1/16 to 1/8 inch (2 to
3 mm) gap
2. Ensure that a 1/16 to 1/8 inch (2 to 3 mm) gap exists
between the control bar and the handle (Refer to
Adjusting the Control Cable on page 12).
