Lavor LVR, Manual, Page: 24 / 56

24
CONTROL PANEL
⑱
Main switch 0/I
Lights:
㉒
Child safety (orange).
㉓
Green LED.
㉔
Yellow LED.
㉕
Red LED.
㉖
Maintenance.
㉘
Overheating.
Start-up
See the "INSTRUCTION MANUAL - SAFETY WARNINGS"
provided.
⑱
Start-up
(model- type: DIGIT)
- Insert the plug in the power outlet, the 0 button
⑱
becomes blue.
- Press the gun lever until water comes out.
- Press the blue I button
⑱
which becomes red.
㉓
Green rectangular light
- The machine is on and working.
㉔
Yellow rectangular light
- The machine is in stand-by. To reactivate it, simply
press the gun lever.
㉕
Fixed red rectangular light
- Safety function. The electrical power supply is
deactivated because the machine has not been
used for more than 15 minutes (prolonged stand-
by). To restart the motor, press key 0 and then key I
⑱
.
㉕
Flashing red rectangular light
- Safety function. The electrical power supply
to the motor is deactivated because of leaks
in the hydraulic circuit.To restart the motor,
press key 0 and then key I
⑱
. See the paragraph
“TROUBLESHOOTING”.
㉒
Child safety
- Press and hold key I for 3 seconds, until the Child
safety symbol
㉒
flashes.
- The water jet does not come out even if the gun
lever is pressed; the buttons are locked too.
- To unlock the machine, repeat the operation.
㉖
Ordinary maintenance
The light
㉖
turns on after at least 10 hours
of operation. See the paragraph "Care and
Maintenance."
- Clean the filter in the water connection.
- Cleaning of nozzle. Use a small paper clip to free
foreign material clogging or restricting spray tip.
- O-Ring Maintenance. The use of lubricant
(petroleum or synthetic grease) helps seat o-rings
providing an improved seal. Apply lubricant to
o-rings prior to assembling high pressure hose
(pump end) , high pressure hose (gun end) ,
garden hose to the pump , and plastic wand (gun
end). Purchase an O-Ring Maintenance Kit by
contacting
- Remove all debris, especially from the ventilation
slots.
- Check high-pressure hose.
- Check the power cable and plug.
- To turn off the light, press key 0, insert the plug
by holding down the key 0 until the light turns off
(about 6 sec.)
㉘
Overheating
- The light
㉘
turns on when the temperature inside
the machine exceeds the preset threshold. It does
NOT indicate a technical problem.
- Move the machine to a ventilated place and/or let
it cool down.
- Turn off the machine by pressing the 0/I button
⑱
and disconnect the plug from the power outlet.