![background image](http://html1.mh-extra.com/html/lavor/lander-2800/lander-2800_instruction-manual_4038376015.webp)
15
•
Caution - Danger!
Only clean or filtered water should be used for in-
take. The water intake should be at least twice the
pump capacity.
- Minimum delivery rate: 15 l/min
- Maximum intake water temperature: 40°C
- Max inlet water pressure: 1Mpa
Place the cleaner as close as possible to the water
supply.
Water supply from the water main
• Connect a supply hose (not included) to the wa-
ter inlet of the unit and to the water supply.
• Open the water supply.
The cleaner can be connected directly to the mains
drinking water supply only if the supply hose is fit-
ted with a backflow preventer valve as per current
regulations in force.
Make sure that the hose is at least Ø 13mm and that
it is reinforced.
Water supply from an open container
• Unscrew the coupling part for the water inlet.
• Screw the suction hose with filter (not included)
onto the water connection of the unit.
• Hang the filter in the container.
• Vent the unit before operation.
-
Unscrew the high-pressure line at the high-
pressure outlet of the unit.
-
Switch on the unit and let it run until water
free of bubbles emerges at the high-pres-
sure outlet.
-
Switch off the unit and screw on the high-
pressure hose again.
Failure to comply with the above conditions causes
serious mechanical damage to the pump and the
loss of warranty cover.
1. Connect the high pressure hose to the unit’s high
pressure outlet (fig.5).
fig. 5
2. Connect the high pressure hose to the spray gun.
Insert the spray wand of your choice into the wand
extension. Press in against the spring tension and
twist into the locked position (fig. 6). Insert the noz-
zle (fig.2A).
fig. 6
3. Connect garden hose to unit’s water inlet
(Max 10 bar, max t. 40° C) (fig. 7).
fig. 7
4.Connect garden hose to the cold
water source and turn water on completely (fig. 8).
fig. 8
13 mm
5. Trigger the gun to eliminate trapped air, wait for a
steady flow of water to emerge from the spray noz-
zle (fig. 9).
fig. 9
•
CAUTION! In order to assist the first startup, it is
recommended to hold the trigger pressed during
the pulling of the starter handle
6. Push the fuel cock to ON position (Fig. 10).
ON
ON
Fuel cock
fig. 10
7. Push the choke lever to the OFF position OFF (Fig.
11).
Summary of Contents for LANDER 2800
Page 2: ...2 11 10 7 12 13 9 1 2 2 4 3 5 8 18 16 ...
Page 116: ...116 ...
Page 117: ...117 ...
Page 118: ...118 ...