NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
© 2020, Lavorwash
Kerosene Forced Air Heater User’s Manual
Assembly Instructions
Models: FF125 / FF175 / FF215
1. Insert axle through holes in wheel support.
2. Slide washer, then spacer onto axle.
3. Slide wheel onto axle and hold in place with the
axle nuts. (See Figure 5).
4. Place heater on wheel support and line up holes
on the fuel tank lip.
5. Attach front handle with (2) long screws
(50 mm) and (2) nuts through the second hole
from the front on both sides of the tank lip and
wheel support frame and tighten firmly.
6. Insert (2) short screws (30 mm) through the first
hole from the front in the tank lip and tighten
firmly. Make certain all (4) screws are secure.
7. Attach rear handle with (2) long screws
(50 mm) and (2) nuts through the third hole from
the rear of the heater on either side. (See Figure
6)
8. Tilt the heater up gently so it is resting on the
front handle.
NOTE: DO NOT do this if there is fuel in the tank.
9. Remove the wheels to secure the second set of
screws through the rear handle.
10. Secure the rear handle with (2) short screws (30
mm) and (2) nuts and tighten firmly
11. Replace wheels and tighten with the wheel nuts.
12. Tilt heater back down onto wheels and check all
screws and nuts to make sure they are secure.
Figure 5
Axle
Axle Nut
Spacer
Tire
Wheel Support Frame
6
Tip: Do not tighten the nuts fully. You will
need to remove the wheels in a later step.
Tip: You will secure the back of the rear
handle in a later step by tilting the heater
up the front handle as shown in figure 7
Figure 6
Front Handle Rear Handle
Unused Hole
Wheel Support Frame
Tank Lip
Figure 7
1
2
