![background image](http://html1.mh-extra.com/html/lavor/eg-p-3600/eg-p-3600_instruction-manual_3961788033.webp)
33
GB
The following symbols are used throughout this
manual:
@
Denotes risk of personal injury or
damage to the machine.
ELECTRICAL sAfETY
@
Always check that the power
supply corresponds to the voltage
on the rating plate.
DEsCRIPTION (fIG. A)
Your water pump has been designed to pump
clean water and waste water. The machine is
not suitable for pumping salt water. The machine
is not intended for permanent use.
1 On/off switch
2 Handle
3 Pump housing
4 Drain hose connection
5 Filling point
6 Supply hose connection
7 Bleeding point
Positioning the pump (fig. A)
n
Place the machine on a flat, stable underground.
Make sure that the machine is not positioned
4 m higher than the level of the liquid to be
pumped.
n
Place the machine on a rubber mat (or a
comparable vibrationabsorbing material) when
using the machine in a permanent setup.
n
Connect the supply and drain hoses.
Mount the supply hose to connection (6) and
the drain hose to connection (4).
n
Place a suction valve with filter on the end of
the supply hose to prevent the supply from
clogging up.
n
Place a check valve directly on the drain hose
to prevent the pump from being damaged by
water hammer.
n
Place a shutoff valve downstream from the
check valve to facilitate servicing.
@
Before installing or moving the
pump always remove the mains
plug from the wall socket.
Connecting the water hose (fig. A)
n
Screw a water hose directly or via a reducing
nipple to the connection.
n
Check whether the hose is connected properly.
@
Before connecting a water hose,
always unplug the tool.
Filling the pump housing (fig. A)
Before each use the pump housing must be
filled with water.
n
Remove the screw from the filling point (5).
n
Fill the pump housing with water until the
level is equal to the edge of the filling point.
n
Reinsert the screw and tighten it securely.
Instructions for use
n
Check whether the hoses are connected
properly.
n
Make sure that the supply hose is
approximately 0.5 m below liquid level.
n
Fill the pump housing with water.
Switching on and off (fig. A)
n
To switch the machine on, set the on/off
switch (1) to ‘I’.
n
To switch the machine off, set the on/off
switch (1) to ‘0’.
@
The pump has been fitted with a
thermal protection. In case of
overload the motor is switched off.
After the motor has cooled down
the pump automatically switches
on again.
CLEANING AND MAINTENANCE
The machine does not require any special
maintenance.
n
Regularly clean the ventilation slots.
n
Defects must only be repaired by an
authorised service station.
@
The pump must not be opened by
the user.
Summary of Contents for EG-P 3600
