THE LAVIT WATER COOLER
TM
Installation Quick Guide
UNPACK AND INSPECT THE COOLER
ON THE OUTSIDE OF
THE STYROFOAM PACKAGING, YOU WILL FIND:
CO2 Regulator
Power Cord
Drip Tray
PLACE THE COOLER
AWAY FROM DIRECT SUNLIGHT
AND HEAT. ALLOW ENOUGH SPACE FOR VENTILATION.
INSTALL YOUR FILTER
START UP AND FILL TANK
1.
Purge CO2 using purge valve on left upper rear side.
2.
Power on to unit
3.
System will self-check with software version
4.
No CO2 Detected Screen will appear then HOME Screen
will display.
DO NOT INSTALL CO2 AT THIS POINT
5.
Press RED flashing Lavit button to fill water tanks
6.
As the still water tank fills, the WATERFILLING screen will
be displayed.
7.
When the HOME screen appears, the compressor,
recirculation pump, and soda pump will start.
8.
Once Water Droplet Icon turns black – move to next step.
AND PLUG IN
CONDENSER
FAN
POWER
SWITCH
POWER Cord
Connection
TOPCOVER SCREWS
CO2
PURGE
VALVE
COLD
TANK
NOW YOU MAY INSTALL THE CO2 TANK
1.
Make sure Regulator is in OFF position
2.
Before turning on your CO2 tank, purge all CO2 from
system using the purge valve on the left rear of the
cooler
3.
Screw Regulator on to CO2 cylinder tightly
4.
Connect Regulator and attached to CO2 inlet line
located inside the right-side door.
DRAIN
1.
Turn off the main water supply
2.
Tap into your mains water
supply
3.
Install your pressure reducing valve
MAX- 60PSI MIN-45PSI
4.
Connect ¼” water supply line to
inlet connection
5.
Connect the Power Cord
1/4"QUICKCONNECTWATERINLET
BEHIND
ABOVE
ALL SIDES
✔
40 to 60 psi pressure reducing valve
✔
¼” quick connect check valve (check local
plumbing codes)
✔
¼” NSF approved water tubing
✔
¼” shut off valve
✔
NSF 42 and 53 rated carbon filter
✔
#2 Phillips head screwdriver
✔
Measuring cup
It is the responsibility of the installer to follow local
codes during installation
4
