THE LAVIT WATER COOLER
TM
Installation Quick Guide
UNPACK AND INSPECT THE COOLER
ON THE OUTSIDE OF
THE STYROFOAM PACKAGING, YOU WILL FIND:
CO2 Regulator
Power Cord
✔
40 to 60 psi pressure reducing valve
✔
¼” quick connect check valve (check local plumbing codes)
✔
¼” NSF approved water tubing
✔
¼” shut off valve
✔
NSF 42 and 53 rated carbon filter
✔
#2 Phillips head screwdriver
✔
Measuring cup
It is the responsibility of the installer to follow local
codes during installation
Drip Tra
y
PLACE THE COOLER
AWAY FROM DIRECT SUNLIGHT
AND HEAT. ALLOW ENOUGH SPACE FOR VENTILATION.
INSTALL YOUR FILTER
START UP AND FILL TANK
AND PLUG IN
1.
Turn off the main water supply
TOPCOVER SCREWS
CO2
PURGE
VALVE
1.
Power on to unit
2.
System will self-check with software version
3.
NoCO2DetectedScreen willappear thenHOMEScreen will
display.
DO NOT INSTALL CO2 AT THIS POINT
4.
Press RED flashing Lavit button to fill water tanks
5.
As the still water tank fills, the WATERFILLING screen will be
displayed.
6.
When the HOME screen appears, the compressor,
recirculationpump,andsodapumpwillstart.
7.
Once Water Droplet Iconturns
black
–
move to next step.
NOW YOU MAY INSTALL THE CO2 TANK
2.
Tap into your mains water supply
3.
Install your pressure reducing
valve MAX- 60PSI MIN-45PSI
4.
Connect
¼”
watersupply line to
inlet connection
CONDENSER
FAN
POWER
SWITCH
COLD
TANK
POWER Cord
Connection
1.
Make sure Regulator is in OFF position
2.
Before turning on your CO2 tank, purge all CO2 from system
using the purge valve on the left rear of the cooler
3.
Screw Regulator on to CO2 cylinder tightly
4.
Connect Regulator and attached to CO2 inlet line
located inside the right-side door.
DRAIN
5.
Connect thePowerCord
1/4"QUICKCONNECTWATERINLET
BEHIND
ABOVE
ALL SIDES
4
