LAVAZZA LM 840 Tiny Eco Rosa, Operating Instructions Manual

Page: 32 / 100

32
IT EN
TROUBLESHOOTING
Problem encountered Possible causes Solution
Water leaks at the rear side of
the coffee machine.
» Tank not inserted correctly.
» Tank damaged. » Insert the tank correctly.
» Check for leaks in the tank keeping it separate from
the machine .
» If the problem remain please contact Lavazza
Customer Service.
Water leaks at the front side
of the coffee machine.
» Capsule stuck.
» Capsule not compatible.
» Open the pod holding tray and remove the pod
found inside.
» Use Lavazza capsules or compatibles.
» If the problem remain please contact Lavazza
Customer Service.
The
SWITCH-ON/
STAND-BY/SUPPLY
button will blink to an orange
light .
» The temperature measured
inside the machine is lower
than 41°F (5° C).
» Generic malfunction.
» Disconnect the plug from the socket, then allow
the machine to rest at ambient temperature for the
necessary time.
(N.B. Depending on the initial temperature, this time
may be of up to 2 hours).
Connect the machine plug again to the socket, then
press push-button.
» Unplug the unit, then plug it again after
approximately 10 seconds.
» If the problem remain please contact Lavazza
Customer Service.
The button will blink fast to a
white colour .
» Tank not inserted.
» Tank not inserted correctly.
» Tank damaged. » Insert the tank.
» Insert the tank correctly.
» Verify that the tank is intact.
» If the problem remain please contact Lavazza
Customer Service.
The coffee flows out too fast
and no creamy froth forms on
the surface.
» Capsule not compatible.
» Capsule already used. » Use Lavazza capsules or compatibles.
» Bring the lever back to rest position and load a new
capsule.
» If the problem remain please contact Lavazza
Customer Service.