Fast guide. Instructions for the user -EN-
rev 03 - 03/2016 - cod. WY02000580
LB4200
coffee - coffee
Control panel LEDs warnings
No water tank or lack of water in the tank
Unit NTC probe open / shorted out
Coffee unit thermoblock heating timeout
Service boiler heating timeout
Used pod drawer full
Used pod drawer open
Perform washing of the unit with the warning.
Replace the tank filter
Unit in stand by (Slow flashing 3 sec)
Perform the descaling cycle
Lack of volumetric dosing pulses (dose button LED selected)
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
Off
Steady on
Slow flashing
Rapid flashing
• verify that there are no pods in the units;
• turn off the machine with the switch
(9)
;
• place a large pitcher under all spouts and make sure the levers of all the units
are closed;
• remove the filter and fill the tank with a solution of 125 ml of "Puly Descaler"
and 400 ml of water at room temperature;
• replace the tank correctly in place.
• the machine performs 5 deliveries with a break of 15 seconds between each other;
• the machine pauses for five minutes, to allow the descaling agent to work;
• remove and wash the tank with warm water, place the filter back inside it, and
then fill it with clean cold water and put it back in place;
• press button
(3)
again within 10
seconds to start the procedure, the
LEDs of buttons
(3)
and
(6)
of both
panels flash slowly;
• press button
(3)
on the right hand
panel to start the rinse;
• wait for the rinse to be completed
(additional dispensing), the LEDs of
buttons
(3)
and
(6)
on both panels
flash slowly.
• after this first phase, the LEDs of
buttons
(3)
and
(6)
flash quickly,
Perform the descaling
The LEDs of buttons
(3)
and
(6)
of
both units flash slowly.
• turn on the machine while holding
down button
(3)
on the right hand
panel, until the LEDs of buttons
(3)
and
(6)
go off;
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
WASH
PROGRAM
Thermoblock descaling
Boiler level led (10)
• on
Correct level
• slow flashing
Filling in progress
• rapid flashing
Filling time out
10