Maintenance manual for technical assistance - LB 2800 - LB 2810
Manual code 10066574 / Rel. 0.00 / March 2009
17
7.6. Programming of boiler temperature
To adjust the temperature of the boiler outlet water,
proceed as follows:
- turn the machine off by moving the
switch to position 0;
- press and hold the STOP/PROG key of the push but-
ton panel and start the machine. At start-up, the
LEDs of the dose keys will flash to indicate the cur-
rently set temperature (temperature = sum of no. of
flashes of each key multiplied by the indicated value);
- to change the temperature, use the dose keys (+ , -)
to increase or decrease the temperature by 1°C.
+
-
x 100
x 10
Note
If you want to obtain a temperature below the mini-
mum that can be set, you can install in the tube of
the dispensing group a choke Ø4 mm, included
with the machine (see plumbing diagram at end of
booklet).
7.7. Coffee dispensing
Put the coffee cup under the dispensing spout.
5
2
2
x 1
- once you have reached the desired value, confirm by
pressing STOP/PROG.
The LEDs will flash again to indicate the new setting.
Then the heating element light will come on and the
machine will start operating;
- turn the programming switch to OFF.
Default temperature: 120 °C
Range: 80 - 125 °C
Suggested temperature: 115 °C
Attention
Programming must be performed by technical
staff.
Use caution when accessing the interior of the
machine (setting the programming lever) due to
the high temperature of some of the components
and the present of live voltage.
5
2
2
ON
ON
3
3
2
5
2
2
.
5
2
2
Insert a pod in the filter holder and attach it to the
group, tightening firmly.
Press the desired dose button (
3
) and wait for coffee to
be delivered (the LED comes on).
To stop the delivery of coffee in advance, press the
delivery button again or press the STOP/PROG button
(
2
).
Note
If you decide to dispense manually, you can use the
STOP/PROG key (2). Press the key to activate coffee
dispensing.
Press again to stop the selection.
Summary of Contents for LB 2800
Page 36: ......
