LAVA Computer MFG Inc.
LAVA nLTS Family Quick Start Guide - Rev A04
2 Vulcan St. Toronto, ON
Tel: +1 416 674-5942
www.lavasimulcharge.com
Canada, M9W 1L2
Toll Free (US & Canada): 800 241-5282
Page 4
Setup Procedure:
1.
Plug the Lenovo USB Charger into an AC power source and connect the Micro-USB
connector into the nLTS port marked “Micro-B USB 5V Power Input”.
For PoE units:
Select nLTS products can be powered using a PoE Switch/Injector,
connected to the Ethernet Port.
For VC units:
Select nLTS products can be powered using a 9-36V (12W or better)
power supply with a 2 mm center positive barrel jack connector, connected to the port
marked “9-36 VDC In”.
The attached power supply and wiring are responsible for
providing short circuit protection.
Note:
If using either PoE or the VC power input,
do not
plug a power supply into the port marked
“Micro-B USB Aux 5V”.
Note:
For VC units, when connecting the LAVA product to the supply, ensure the wiring is such that
the center pin is positive. If the polarity is reversed, the damage to the LAVA product i
s
immediate.
Application of the wrong input voltage violates LAVA’s Manufacturer Warranty.
2.
Once connected, the green and yellow status LEDs will start blinking in unison to indicate
that the unit is receiving power.
3.
Plug one end of the Micro-USB cable supplied by LAVA into the mobile device’s Micro-USB
port, and the other end into the nLTS port marked “To Tablet”. Ensure the Micro-USB
connector is oriented correctly as you’re plugging it in. Orienting it incorrectly can
damage both the cable and the LAVA product’s Micro-USB port.
4.
Once connected, the green status LED will start blinking rapidly to indicate that a mobile
device has been detected. Once the green status LED is solid, a connection has been
established with the mobile device.
5.
Plug your peripherals and/or Ethernet cable into network (if applicable).
