When the heat function is used for the first time, a slight odor may be present. This is normal and
should not occur again unless heater is not used for an extended period of time.
Flame effect / Light bulb replacement
Caution! Bulbs will become very hot; allow at least 10 minuets for bulbs to be cool
before touching
The flame effect on this electric stove heater is created by two 40 watt light bulbs with an
E-12 (small) socket base. Only use this type of light bulb. To service light bulbs, unplug
power cord from outlet, locate access panel on back of stove. Remove screws and panel.
Light bulbs may come loose or may be damaged during shipping. If flame effect does not
work properly, check to be certain that both bulbs are finger tight and are in working
order. Replace light bulbs as needed. Replace access panel. Do not operate with out
access panel in place. Do not remove back cover of heater; no serviceable parts.
Controls / Operation
After reading safety instructions and this entire manual, be certain that the controls are in
the off position.
Controls are located on the right side of heater
Your heater stove is now ready for operation:
Plug unit into a grounded 15 amp. 110 / 120 Volt outlet.
Operating the Remote Control
ON/OFF: press this button to turn on the main power.
1.
Flame/Log: Press this button to turn on the flame effect.
2.
750W power button: Press this button and the fireplace will operate at 750W.
Pressing again will switch the heater off.
3.
1500W power button: Press this button and the fireplace will operate at 1500W.
Pressing again will switch the heater off.