Parallel Configuration
1. Determine the number of
parallel ports already installed
in your system.
2. If you have two parallel ports
already installed, set the Parallel
Bi-directional card to LPT 0 -
address 3BC (ignore IRQ
jumper). The Parallel Bi-
directional card will now act as
your PC's primary parallel port
and will be seen by your
operating system as LPT 1. All
other LPT port designations will
be increased by a factor of 1.
3. If you have one parallel port
installed, set the configuration
jumpers for LPT 2 (address 278),
IRQ 5 as shown.
4. If you have no parallel ports
installed, set the configuration
jumpers for LPT 1 (address 378)
IRQ 7, as shown.
5. If desired, the Parallel Bi-
directional card may be
reconfigured for either bi-
directional mode or for output
only.
1. Il faut determiner combien
des ports parallèle en votre
système.
2. Si vous avez deux ports
parallèle, ajouter le Port de
Lava pour LPT0 (03BC hex).
N'importe quoi l'IRQ. Le Port
de Lava sera le Port Parallèle,
primaire (LPT 1). Les autres
sera LPT 2 (0378 hex) et LPT 3
(0278 hex).
3. Si vous avez un port parallèle,
ajoutez le Port de Lava pour
LPT2 (0278 hex), IRQ 5.
4. Si vous n'avez pas un port
parallèle, ajoutez le Port de
Lava pour LPT 1 (0378 hex),
IRQ 7 [default].
5. Si vous desirez, le Port
Parallèle peut utilizer la
mode bi-directionelle, ou
uni-directionelle.