C2000 Debugger | 49
©
1989-2023
Lauterbach
SYStem.Option.AHBHPROT
Select AHB-AP HPROT bits
Default: 0
Selects the value used for the HPROT bits in the Control Status Word (CSW) of a CoreSight AHB Access
Port, when using the AHB: memory class.
SYStem.Option.AXIACEEnable
ACE enable flag of the AXI-AP
Default: OFF.
Enables ACE transactions on the DAP AXI-AP, including barriers. This does only work if the debug logic of
the target CPU implements coherent AXI accesses. Otherwise this option will be without effect.
StandBy
You need to be in DOWN state when switching to this mode. It resets and
starts the program when power is detected. Halt the program execution
and set all the breakpoints and trace conditions you need, then re-start
the program. Now you can even debug a power cycle, because debug
register (breakpoints and trace control) will be restored on power up. This
mode is available on ARM7, ARM9 and ARM11 family.
Up
Resets the DSP and establishes the connection. After the execution of
this command the DSP is stopped and all register are set to the default
level.
Format:
SYStem.Option.AHBHPROT
<value>
(deprecated)
Use
instead.
Format:
SYStem.Option.AXIACEEnable
[
ON
|
OFF
] (deprecated)
Use
SYStem.CONFIG.AXIAPn.ACEEnable
instead.
