LAUREL Electronics MAGNA Series, Installation & Operating Manual, Page: 20 / 47

20
Simple Rate Mode
Rate mode is ideal for showing instantaneous speed, RPM, frequency, production rate, flow
rate etc. For production rate showing the true number of items produced in the last hour,
consider using our ‘Production Rate Mode’ method, which is ideal for production which is
erratic or has periods of widely differing production rate.
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Press to accept
Done!
Set1 Set2 Output Alarms
Digit
OK
Max/Min Reset
Av. 00 Av. 00
Av. 00 Av. 00
Av. 00
(4 digits) or
Avg. 00 Avg. 00
Avg. 00 Avg. 00
Avg. 00
(6 digits) will appear,
prompting you to enter a number of readings to
average, from 00 to 99. The bigger the number, the
smoother the display, but the response to change
will be slower.
Set1 Set2 Output Alarms
Digit
OK
Max/Min Reset
dl03 dl03 dl03 dl03 dl03
(4 digits) or
del 03 del 03 del 03 del 03 del 03
(6 digits) will appear,
prompting you to enter a delay time in seconds, so
that if no pulses are received within this time, the
display will revert to showing 0.
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Lockout Switch must be OFF
Press 3 seconds
OFF
Circuit board ON
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Press to scroll through the available mode
choices. Select
rate rate
rate rate rate
and press OK
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
fr.in fr.in fr.in fr.in fr.in
(4 digits) or
freq.in freq.in freq.in freq.in freq.in
(6 digits) will appear,
prompting you to enter a frequency in Hz, which will
correspond to a desired display value. Use Digit, Up
and Down buttons to set, and press OK to accept.
You can move the decimal point during setting by pressing the UP button for a few seconds,
then repeatedly press to shift the position.
Set1 Set2 Output Alarms
Digit
OK
Max/Min Reset
disp disp
disp disp
disp
will appear, prompting you to enter a display
value, which will correspond to the frequency you
entered. Use Digit, Up and Down buttons to set,
and press OK to accept.
You can move the decimal point during setting by pressing the UP button for a few seconds,
then repeatedly press to shift the position.
1
2
3
4
5
6
7