Before using this test equipment, please read the following
safety information carefully.
Ÿ
Always perform automotive testing in a safe environment.
Ÿ
Do not connect or disconnect any test equipment while
the ignition is on or the engine is running.
Ÿ
NEVER smoke or allow a spark or flame in vicinity of
battery or engine. Do not operate the tool in explosive
atmospheres, such as in the presence of flammable
liquids, gases, or heavy dust.
Ÿ
Use extreme caution when working around the ignition
coil, distributor cap, ignition wires and spark plugs. These
components create hazardous voltage when the engine is
running.
Ÿ
Wear an ANSI-approved eye shield when testing or
repairing vehicles.
Ÿ
DO NOT attempt to operate the tool while driving the
vehicle. Have second personal operate the tool
.
Any
distraction may cause an accident.
Ÿ
Put blocks in front of the drive wheels and never leave the
vehicle unattended while testing.
Ÿ
To avoid damaging the tool or generating false data,
please make sure the vehicle battery is fully charged and
the connection to the vehicle DLC (Data Link Connector)
is clear and secure.
Ÿ
Before starting the engine, put the gear lever in the
Neutral position (for manual transmission) or in the Park
(for automatic transmission) position to avoid injury.
Ÿ
Keep a fire extinguisher suitable for
gasoline/chemical/electrical fires nearby.
Ÿ
Automotive batteries contain sulfuric acid that is harmful
to skin. In operation, direct contact with the automotive
batteries should be avoided. Keep the ignition sources
away from the battery at all times.
Ÿ
Keep clothing, hair, hands, tools, test equipment, etc.
away from all moving or hot engine parts.
Ÿ
Do not use the tool while standing in water.
Ÿ
Keep the tool dry, clean, free from oil, water or grease.
Use a mild detergent on a clean cloth to clear the outside
of the equipment when necessary.
Ÿ
Do not expose the tool or power adaptor to rain or wet
conditions. Water entering the tool or power adaptor
increases the risk of electric shock.
Ÿ
Do not install programmed TPMS sensors in damaged
wheels
.
Ÿ
While programming a sensor, do not place the device
close to several sensors at the same time, or the tool will
detect more sensors, which may result in programming
failure.
Address: Heinrich-Hertz-Str. 10, D-50170 Kerpen
THANK YOU FOR CHOOSING LAUNCH!
If you have any questions on the operation of the unit, please contact
LAUNCH Europe GmbH customer service center:
Phone: +49 (0) 2273 9875 55
E
N
E
N
Safety Precautions