Quick Start Guide
123X
Preparation
3
Diagnostic Cable
1. Turn the ignition off.
2. Locate vehicle's DLC: It
provides standard 16 pins
and is generally located on
driver's side, about 12
inches away from the
center of dashboard. See
Figure
DLC Location
. If
DLC is not equipped under
dashboard, a label
indicating its position will
be given.
3. Plug one end of the diagnostic cable into the DB-15 connector of
the tool, and tighten the captive screws. Connect the other end to
the vehicle's DLC.
Vehicle
DLC
Display Tablet
*Note: The tool ONLY works with the 12V passenger cars equipped with
standard OBD-II diagnostic socket.
4. Turn the ignition key on.
In case no DLC is found, please refer to Automobile Repair Manual.
Start Diagnostics
4
AutoDetect and manual diagnosis are supported. If the AutoDetect
fails, you can choose to input the VIN manually or exit the AutoDetect
session to switch to manual diagnosis mode.
Tap “Diagnose”*
Start decoding vehicle VIN
Decoding OK
Decoding failed
Double check vehicle info.
Select vehicle manufacturer
Scan all vehicle systems
Select vehicle make
Output diagnostic report
Select test system
Select diagnostic function*
Diagnostic Flowchart
Manual Diagnosis Flowchart
*If you are fresh to vehicle
diagnostics, you are suggested
to use "DEMO" to get familiar
with the diagnostic process.
Input the VIN, and tap "OK", the system will automatically identify the
vehicle model. If the vehicle VIN is successfully decoded, it will perform
auto-diagnosis until a diagnostic report is automatically output.
*Note: The most recognizable location for VIN is in the top left corner on the
vehicle's dashboard. Other locations include the driver's door or post, and the
firewall under the hood.
*Note: If "Automatic detection on connect" in "Settings" is set as ON, this
step can be ignored.
+86 755 8455 7891
Summary of Contents for Creader Professional 123 Series
Page 3: ...210mm x 148mm 1 1 80g...
