- 32 -
NUMBER OF BATCHING PRINTOUTS
(from 1 to 9; default: 1): number of copies of the batching printout.
CHECKING PC PRESENCE
(default:
): check for a PC connected to the instrument.
-
: PC presence check active; the instrument checks for a PC every 10 seconds. If no PC
presence is detected, the instrument will display an alarm signal
alternated with the weight
value.
-
: PC presence check not active.
WARNING:
The check is active only if selected the Modbus protocol.
WAITING CONFIRMATION FROM PC (SLAVE)
(default:
): waiting for confirmation of record batching data from PC.
-
: check enabled; the instrument waits for the PC to read the batching data, before starting
another batching. In case of recording failure, the instrument displays an alarm
.
-
: check disabled; at cycle end, the instrument will not wait for data recording on PC before
performing another batching.
SWITCHING OF THE ALARM/TOLERANCE RELAY ON WEIGHT
(from 0 to max full scale; default:
): by setting a value different from zero, the
ALARM/TOLERANCE contact does not switch over in case of alarm/tolerance, but behaves as a
SETPOINT contact; the relay closes when the weight reaches the value set in this parameter.
BIG BAG UNLOADING
BIG BAG UNLOADING enabling function. This function must be enabled when, during
batching, it is necessary to fully unload the scale (for example in case of big bags or containers
already prepared). It only works if minimum and maximum weight values have been set. Batching is
allowed even if an amount lower than the figure set in the formula is detected on the scale. Batching
is carried out as follows: when the weight has reached the minimum set and the safe emptying time
has elapsed (
), batching will be interrupted and AUTOMATIC LOADING will be enabled (the
operator must replace the container or the big bag); after this phase ends, press the ENTER key or
close the START contact to resume batching from the point of interruption, press the STOP key to
cancel the batching.
Summary of Contents for W200-S
Page 5: ...KEYPAD OR DISPLAY LOCKING 44 DECLARATION OF CONFORMITY EU 45...
Page 16: ...11 BATCHING CONSTANTS it appears only if in constants TOTAL YES...
Page 51: ......
Page 52: ......
