DE/FR/IT/EN/ES/NL
8
2 seconds „beep“ prior
flushing
--> weak batteries
Action item: Replace battery
shortly
2 seconds „beep“ after use
of urinal,
no
flushing
--> dead batteries
Action item: Replace battery
immediately
Activate cleaning
and diagnosis
1.
2.
3.
4.
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
beeeep
5 minute suspension:
The flushing program
stops for 5 minutes (“beeps” during the pause) to allow the urinal
to be cleaned manually. The complete rinse is now activated.
The control unit switches back to its pre-set mode.
Full flush:
A flush is activated. The control unit
switches back to its pre-set mode.
Interval cleaning:
The control unit initiates
5 short flushes at preset intervals of 2 minutes.
This allows, for example, descaler to work.
Finally there is a full flush, after which the control
unit returns to the pre-set mode.
Cleaning programs
Diagnosis of system
(approx. 10 seconds)
1 x „beep“ + flush = system o.k.
1 x „beep“ no flush = solenoid valve
problem
Please check:
1. Connection control unit <-> solenoid
valve
2. Water supply
3. Solenoid valve
2 x „beep“ = sensor problem
Please check:
1. Connection control unit <-> sensor
2. Sensor
3. Electronic module
3 x „beep“ = Weak batteries:
Replace
Explanation of symbols
Battery monitor
Place the mag-
netic key on the
logo and hold it
there
Now remove the
magnetic key
from the logo
again
