R6
Loosen bolt with 4 mm
hex/allen key.
Tighten to 7 Nm afterwards.
Slide saddle back or forth.
Tilt saddle back/forth
Saddle:
The saddle can be adjusted in tilt and moved back/forth. Most like their saddle horizontal to
the ground but some with a little tilt. To tilt it, follow the diagram (
R6
) below. The saddle is
set in the middle but to micro adjust the reach, the saddle can be moved back or forth at the
same time when tilting the saddle.
R4
R5
Loosen bolts with
4mm hex/allen key.
Remove top-cap with
6mm hex/allen key.
Remove spacers.
1.
2.
3. Add desired spacers
beneath the stem.
4. Flip the stem up for a
more up right riding
position.
SPACER
SPACER
SPACER
Tighten bolts with 4mm
hex/allen key after
adjusting the stem in-line
with thte tire.
Adjust the handelbar
and tighten the bolts
according to the
Assembly Guide.
Fasten top-cap with 6mm
hex/allen key. Remember
to have min. 5mm of
spacers above the stem
and max 30mm below.
1.
2.
3.
SPACER
SPACER
SPACER
Stem:
The bike is delivered with the maximum amount of spacers (20mm below the stem and
15mm over the stem). There should always be at least 5mm of spacer above the stem. The
stem can be adjusted in two ways to accommodate different rider fit. Either by moving it up
or down by putting spacers that are above it underneath it and/or by flipping the stem up-
side down. This will allow the rider to go from a very racey (
R4
) postion to a more
up-rigth position (
R5
). Remember to check the “Assembly Guide” or the stem
manufacturer’s guide lines when tightening.
