Lauda Proline RP 1290 C, Operating Instructions Manual

Page: 70 / 120

Proline Edition X cooling thermostats
70
Starting up
YACE0100 / October 4, 2018
7.12 Timer function
Using the timer function, the thermostat can carry out an action at a certain time or after a certain
waiting period. The actions are: switching on the thermostat, entering the standby mode or one of the
five programs in the programmer.
Command
Clock Timer 1 Timer 2

Open the device parameter menu via the
soft key Menu .

With the cursor keys continue to:

Clock

Timer 1 ,

or to Timer 2 ,

with the menu Status the selected timer
is switched off or on .

The standby key does not stop the timer!
Please exercise caution when thermostat is in standby mode. The thermostat is not
switched off safely.
A previously activated timer mode could unintentionally start the thermostat again
from the standby mode.
The menu Function is used to define when
an action is executed:

Similar to an electronic mains timer,
Weekplan enables two switching events
to be carried out each day. The cycle is
repeated after 7 days.

Time absolute defines a time and a date
on which a once-only action (switching
event) occurs. The time point is set with
Set time and with Set date .

Time relative defines a waiting period
after which a once-only action occurs.
With
Set time up to 99h: 59min can be
entered. ("Set date" is masked out with
this function selection.)

If the Weekplan is activated, in this
window only Status , Function and
Weekplan are displayed.
Pump Menu End T
set
T
fix
Set time
Set date
Timer 1
Timer 2
Format of date
Pump
Settings
Graph
Clock
Programmer
Interfaces
Control
Limits
Pump Menu End T
set
T
fix
Weekplan
Time absolute
Time relative
Status
Function
Action
Set Time
Set Date