Lauda PROLINE P 5 C, Operating Instructions Manual

Page: 64 / 120

64 / 123 Proline heating thermostat 02/2022

In addition, the standby key stops the pro-
grammer! Pump and heater are switched off.
Follow the safety information (

7.7.3).

After pressing the standby key again, the
programmer returns to the previously selected
operating mode:
Pause or active operation depending on what
was previously selected.
7.10.4 Creating or modifying a program (Edit)
Here, there are the following functions:
 Entry of a program.

Display of the program data of a saved program and modification of the segment data.
 Insertion or appending of a new segment.

Deletion of a segment.


In addition, when a program has just been executed, new segments can be inserted and existing
ones modified, even the currently active segment. Furthermore, all segments, except the cur-
rently active one, can be deleted at any time.

Modifications to the currently running segment are possible. The segment then continues as
though the modification had been applicable since the start of the segment.
However: If the new segment time is shorter than the segment time that has already
run, then the program skips to the next segment.
 If a segment time >999h:59min is required, then this time period must be shared over a number
of consecutive segments.
Entering a program: Program example (

7.10.1).
Pump Menu End Prog.1 Standby
Status
Edit
Loops
Graph
Info
Continue
Stop