Step By Step Instructions
Loosen the bolts on the adjustable brackets
on the non
-
motor end of the mechanism.
Spread the pulley brackets outward against
the walls of the cover box.
Anchoring
t
he Pulley Brackets
Anchor the motor mechanism brackets into
the cover box in as many places as possible.
Use the appropriate screws and anchors
depending on the type of cover box being
used.
Align the mechanism on the motor side first
by using a length of rope and extending it
from the back side of the cover track to the
pulley to make sure the rope will feed
directly into the pulley.
On the non motor end, make sure the rope
will travel straight from the track to the
pulley.
Extending
t
he Pulley Brackets
Loosen the nuts in the four positions on the
adjustable brackets of the motor end of the
mechanism. Spread the brackets outward
against the walls of the cover box.
Raise the pulley brackets up so that the
top of the bracket is even with the top of
the encapsulation. This insures the ropes
will be level.
Tip: before raising the pulley brackets,
make sure the feet are set as high as
possible without the roll up tube rubbing
on the lid.
With the brackets in position, place a small
level across them to make sure they are level.
Tighten the four nuts on the adjustable
motor end brackets.
16
17
18
Anchoring the Mechanism Feet
With the mechanism centered between the
tracks and centered in the cover box front to
back, anchor the mechanism mounting feet
into the cover box. Use the appropriate
screws and anchors depending on the type of
cover box being used.
13
10
1
4
15
12
With the brackets on the non
-
motor end in
position, place a small level across the
brackets to make sure they are level.
Tighten the nylock nuts on the adjustable
brackets.
© Latham Pool Products, Inc. 201
9
. All rights reserved.
1
1
8
