Lassco Wizer Spinnit FMMH-3, User Manual

Page: 9 / 24

3 - Setting Up Your Machine
3.6 - Attaching the Paper Side Stops
Page 08
3.6.1
Diagram 3-30
Attach the Paper Side Stops using two (2) Side Stop Screws
(FM4-4007) each. Position the Paper Side Stop as desired and
tighten down with light pressure.
3.7 - Attaching the Chip Bag
3.7.1
Diagram 3-50
Attach the Chip Bag (FMM6-652A) to the machine by stretching
the mouth of the bag over the Master Chip Chute and hooking
the aluminum bar onto the bracket located on the top flat portion
of the master chip chute as shown. Please note that you must
empty this bag as needed to avoid clogging.
Master Chip Chute
Chip Bag
3.8 - Electrical Instructions
3.8.1
3.8.2
Your FMMH-2 comes with an electrical cord containing the plug to
fit into standard grounded 115V outlets. This machine has a com -
bined full load draw of 18.8 Amps and requires a 20 Amp Circuit.
Making sure that nothing is interfering with the drill bits, plug the
cord set into a grounded 115V outlet. To turn the Drill Motor on,
face the machine and press the Rocker Switch on the left-hand
side labeled “Drill Motor.” To turn the Table Motor on, face the ma-
chine and press the Rocker Switch on the right-hand side labeled
“Table Motor.”
Diagram 3-60
Rocker Switch
(Drill Motor)
Rocker Switch
(Table Motor)
Table
Paper Side Stop
Side Stop Screws