Page
2
CP-2502/2503/2510/2511/2513/2520/2521/2523/2530/2533
LASKOMEX PPUH
, ul. D¹browskiego 249, 93-231 £ód, tel. (42) 671 88 00, fax (42) 671 88 88, e-mail: [email protected], http://www.laskomex.com.pl
1. SAFETY AND USAGE CONDITIONS
- Prior to the installation please read the following instruction.
- Electric installation should be done in accordance with PN-IEC-60364-1 norm by the
authorized person. Installation should not be directly exposed to atmospheric electrostatic
discharge.
- It is forbidden to connect the panel to other installations, with exception of the application
recommended by the producer.
- Self maintenance is only permitted for qualified persons. Device maintenance by unauthorized
persons may result in the lost of warranty.
- It is forbidden to connect power supply from sources with different parameters than
recommended by the producer to panel clamps. The producer is not responsible for any
lost occurred due the usage of improper power supplies.
- Signals from the digital entry phone system should not be directly connected to RTV sets,
because of risk of devices and system damages.
- View distortions occurred when raining or just after rain are temporary, they are associated
with water gathering near camera lens and should not be perceived as symptom of device
damage.
- Outdoor panel should not be sealed (i.e silicon), cause it worsens ventilation and leads to
corrosion.
- Dirt on the keyboard (snow, mud) may cause faulty operation - in such case dirt should be
immediately removed.
- Do not clean the panel with gasoline, solvents or strong detergents as it may cause damage
of the device surface.
2. OUTDOOR PANEL ASSEMBLY
Panel installation can only be carried out when power supply is off !
If possible outer panel should be installed inside wind shields as it is better secured
against atmospheric factors.
Lens located in the camera panel must not be pointed directly to strong light source (the
sun, strongly lightened street lamp), cause it may seriously or completely limit observation
of speakers faces.
Panel should be installed on the proper altitude providing comfortable usage of the device
for all users. Suggested altitude is approx. 150 cm. Install the device lower in order to
enable usage for disabled and invalids.
When installing panels make certain to provide proper ventilation for each unit. For that
reason it is not recommended to seal the space between the frame and the panel with
silicon or foam etc.
When installing panel with the tenants list make certain to write down names before
riveting the device.
Mounting under the plaster.
In the wall cut out an opening of the dimensions that would enable to place the external
panel freely in it and the frame should completely cover the opening edges. Then 4 holes
o 10 mm should be drilled for strut pins. The tightening force (important when the cut out
opening is deeper than depth of cassette) should be matched to avoid bending of a frame.
Make electrical connections and fix panel with a keyboard by two M4 screws and two rivets
(included in the set).
