NEW 6/21
4
CC23630ES
SAFETY FEATURE
1. A Tip-Over Switch is built in to prevent operation if the Heater is tipped over.
2. A thermal overload protector is built in to prevent overheating.
3. If an overheat temperature is reached, the Heater will automatically shut off. It can only resume operation when the user resets the unit.
To Reset Heater:
1. Unplug the Heater and wait 10 minutes for the Heater to cool down.
2. After the Heater has cooled down, plug the unit into a 120V~ electrical outlet and follow the operation instructions described in this manual.
TROUBLE SHOOTING TIPS
If your Heater shuts off unexpectedly or fails to operate, the previously mentioned safety feature may have been activated to prevent overheating.
1. Be sure the power cord is plugged into a working electrical outlet.
2. Make certain the batteries in the remote control are new and properly installed.
3. Check your Temperature setting. The Heater may be off because it has reached the desired temperature setting.
4. If your Heater runs for several minutes and shuts off repeatedly, your Heater may require cleaning. See Maintenance section below.
SERVICING:
For servicing, other than general user maintenance, please contact Customer Service at (800) 233-0268, Monday through Friday, from 8am-5pm Eastern.
STORAGE:
Store the Heater with these instructions in the original carton in a cool, dry place.
DISPOSITION
: Corrugated packaging materials are recyclable. For environmentally responsible disposal of this product, contact your local waste service provider
or visit www.1800recycling.com
®
.
MAINTENANCE
To reduce the risk of electrical shock and fire please observe the following instructions.
Cleaning the Heater regularly will help to maintain its efficiency.
- Always unplug the cord before moving, servicing or cleaning.
- NEVER place the Heater in or near water. DO NOT IMMERSE HEATER IN WATER.
- Clean the Heater only with a vacuum equipped with a brush attachment; the vacuum will remove
the lint and dirt from the surface of the Heater.
- Vacuum intake grills every two weeks; this will help to maintain the optimum Heater performance.
- Use a toothbrush or other soft bristle brush to gently loosen any dirt not removed by the vacuum.
- NEVER attempt to take apart the Heater.
- Clean the body of the Heater with a soft cloth only.
- NEVER use ALCOHOL or SOLVENTS such as gasoline, benzene, paint thinner, or other harsh cleaners.
LASKO PRODUCTS, LLC LIMITED WARRANTY
(
VALID IN THE USA, ITS TERRITORIES, AND CANADA ONLY)
WHAT THIS WARRANTY COVERS
: This product is warranted against defects in workmanship and/or materials.
HOW LONG THIS WARRANTY LASTS
: This warranty extends only to the original purchaser of the product and lasts for three (3) years from the date of original purchase or
until the original purchaser of the product sells or transfers the product, whichever first occurs.
WHAT LASKO WILL DO
: Lasko will, at its sole option, repair or replace any part or parts that prove to be defective or replace the whole product with the same or comparable
model. For all warranty claims, the product must be returned to Lasko Products, LLC at customer expense with proof of purchase within the warranty period. Contact the
Lasko customer service department to obtain a Return Authorization (“RA”). DO NOT return products without an RA or the warranty claim will not be processed.
WHAT THIS WARRANTY DOES NOT COVER
: This warranty does not apply if the product was damaged or failed because of accident, improper handling or operation,
shipping damage, abuse, misuse, unauthorized repairs made or attempted, or the use of the product for commercial or nonresidential service. This warranty does not cover
shipping costs for the return of products to Lasko for repair or replacement. Lasko will pay return shipping charges from Lasko following warranty repairs or replacement.
ANY AND ALL WARRANTIES, EXPRESSED OR IMPLIED (INCLUDING, WITHOUT LIMITATION, ANY IMPLIED WARRANTY OF MERCHANTABILITY), LAST THREE YEARS
FROM THE DATE OF ORIGINAL PURCHASE OR UNTIL THE ORIGINAL PURCHASER OF THE PRODUCT SELLS OR TRANSFERS THE PRODUCT, WHICHEVER FIRST
OCCURS AND IN NO EVENT SHALL LASKO’S LIABILITY UNDER ANY EXPRESS OR IMPLIED WARRANTY INCLUDE (I) INCIDENTAL OR CONSEQUENTIAL DAMAGES
FROM ANY CAUSE WHATSOEVER, OR (II) REPLACEMENT OR REPAIR OF ANY HOUSE FUSES, CIRCUIT BREAKERS OR RECEPTACLES. NOTWITHSTANDING
ANYTHING TO THE CONTRARY, IN NO EVENT SHALL LASKO’S LIABILITY UNDER ANY EXPRESS OR IMPLIED WARRANTY EXCEED THE PURCHASE PRICE OF THE
PRODUCT AND ANY SUCH LIABILITY SHALL TERMINATE UPON THE EXPIRATION OF THE WARRANTY PERIOD
.
Some states and provinces do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or consequential damages, so these exclusions
or limitations may not apply to you. This warranty gives you specific legal rights. You may also have other rights which vary from state to state and province to province.
Proof of purchase is required before a warranty claim will be accepted.
CUSTOMER SERVICE:
Toll-Free (800) 233-0268. Email: [email protected]
Our Customer Service team is available to assist you with product and service questions, and replacement parts. They can be reached Monday through Friday,
8am-5pm Eastern. Please have your model number available, as well as the type and style (located on the underside of your product).
Customer Service Dept., 820 Lincoln Ave., West Chester, PA 19380
(Please do not send product to this location) www.lasko.com
PARTS FOR DISCONTINUED, OBSOLETE AND CERTAIN OTHER PRODUCTS MAY NOT BE AVAILABLE. DUE TO SAFETY REASONS, MANY ELECTRONIC
COMPONENTS AND MOST HEATER COMPONENTS ARE NOT AVAILABLE TO CONSUMERS FOR INSTALLATION OR REPLACEMENT
.
Manual printed in China
AUTO ECO
™
THERMOSTAT
Pressing the ( ) or ( ) buttons while in any Heater function or speed will turn on
the Auto Eco™ function.
1. To set the room at a specific temperature press the ( ) or ( ) buttons to the
desired temperature. The temperature will be flashing on the display. The Unit
is now in Auto Eco™ Mode.
2. When you reach the temperature at which you want to set the unit, the set
temperature will flash several times and then the display will return to indi-
cate the current room temperature and will gradually change as the room
temperature changes. NOTE: the temperature display does not indicate the
temperature of the heated air being emitted by the Unit.
3. Heater will run on HIGH heat when the ambient temperature is less than the
set temperature.
4. Heater will run on LOW heat when ambient temperature reaches set tem-
perature and will continue to run on LOW heat until ambient temperature
reaches 2 degrees fahrenheit above set temperature.
5. Heater will turn OFF once the ambient temperature is greater than 2 degrees
fahrenheit above set temperature. The fan will continue to run for 15 seconds
after the heater element is turned off.
All of this happens automatically with Lasko Auto Eco™ Technology. To de-
activate the Auto Eco™ function, turn the Unit off or press the (
) button.
NOTE:
In Auto Eco™, the Unit will display the current room temperature in °
Fahrenheit. Press the ( ) and ( ) buttons at the same time to change
the display to ° Celsius. Press the same two buttons together again
to change the display back to ° Fahrenheit.
AUTO-DIMMING DIGITAL DISPLAY
After 10 seconds the lights on the display will automatically dim. Touching any
button will reilluminate the lights to 100%.
REMOTE CONTROL
All the functions performed with the Remote Control work identically to the
manual controls.
1. Install two “AAA” batteries (included).
2. Do not mix old and new batteries. Do not mix al ka line, stan dard (carbon-zinc)
or rechargeable (nickel-cad mi um) batteries.
3. DO NOT DISPOSE OF BATTERIES IN FIRE. BAT TER IES MAY EXPLODE OR LEAK.
4. Always purchase the correct size and grade of battery most suitable for the
intended use.
5. Replace all batteries of a set at the same time.
6. Clean the battery contacts and also those of the device prior to battery installation.
7. Ensure the batteries are installed correctly with regards to polarity (+ and -).
8. Remove batteries from equipment that is not to be used for an extended
period of time.
9. Remove used batteries promptly.
If you lose your remote control, please call Customer Service to order a replace-
ment at (800) 233-0268, Monday through Friday, between the hours of 8:00 a.m.
and 5:00 p.m. EST.
NEW 6/21
5
CC23630ES
Desde 1906
Utilizado para Modelo:
CC23630
LEA Y GUARDE ESTAS INSTRUCCIONES
Lea cuidadosamente las instrucciones antes de intentar armar, instalar, usar o dar mantenimiento al producto
descrito. Protéjase a sí mismo y a los demás cumpliendo con toda la información de seguridad. El no seguir las
instrucciones podría resultar en lesiones personales y/o daños a la propiedad.
Este Calefactor está diseñado para ser usado como calefacción complementaria. Este Calefactor es para uso
residencial únicamente. No está destinado para ser usado en instalaciones comerciales, industriales o agricultura.
Tiene Preguntas? Necesita una Parte?
Por favor no regrese el producto a la tienda!
Contacte al departamento de servicio al cliente
de Lasko Products: (800) 233-0268
Lunes - Viernes 8am a 5pm (Tiempo del Este)
(Válido en EE.UU., sus territorios, y Canadá únicamente)
Calentador
de
Habitación Completa
Revolution
con
Control Remoto Digital
Manual de Instrucciones
Registre su producto hoy
www.lasko.com/product-registration
Podrás disfrutar de los siguientes beneficios:
- Soporte eficiente y avanzado
- Actualizaciones acerca del producto en el futuro
Escanee con un teléfono inteligente
