background image

CAUTION:  Do  not  pour  water  through 
the Exhaust Grill on the Upper Housing.  
Doing so may cause damage and personal 
injury.

CAUTION: 

 

• 

Unplug Unit when filling.

 

• 

Always place Humidifier on a firm level surface.  

 

 

Locate  the  Power  Cord  so  the  Humidifier  is  

 

 

not resting on it, and is away from traffic.

 

•  Be careful not to overfill.

 

• 

Do  not  pour  water  through  Exhaust  Grill,

  

 

 

doing so may cause damage and personal injury. 

 

•  Take  extra  care  to  prevent  water  spillage

 

 

 

that  may  damage  furniture  or  flooring. The  

 

 

manufacturer will not accept responsibility for  

 

 

damage to property caused by water spillage. 

 

•  Always be sure the Power Knob is in the 

OFF

  

 

 

position  when  plugging  Humidifier  into  a  

 

 

grounded 120 volt AC wall outlet. 

 

•  To prevent risk of electrical shock and injury to 

 

 

 

persons,  do  not  plug  Humidifier  into  electrical  

 

 

outlet with wet hands.

1.

  It is recommended that all Humidifiers be cleaned prior to use. 

Please read 

Cleaning Instructions

 for Base and  Jug cleaning.

2.

  Use the convenient Carrying Handle  found on  the bottom  of 

the Water Jug to bring it to a faucet. The Water Jug features a 
‘Quick Fill/Quick Empty’ Spout. To fill, hold Jug upside down 
by the Handle. Use thumb to press down Stopper Lever, and fill 
Jug. Fill the Water Jug with cool tap water. 

Never use hot water.

 

(Figure 3)

When the Jug is replaced back into the Base it will quickly empty 
to fill Base.

NOTE: While carrying filled Water Jug back to the Humidifier, hold 
the Handle with one hand, while supporting bottom of Water Jug 
with other hand.

3.

  Place  the  Water  Jug  securely  in  the  Base.  If  positioned 

 

properly, water will quickly pour into Base and automatically 
stop when reaching desired amount.

4.

  When gurgling noise stops lift up the Water Jug to see if it is empty. 

Refill if empty. When the Unit is full some water will remain in 
the Jug.

5.

  Even though your Humidifier will produce approximately 9.0  

gallons  in  a  24  hour  period*,  the  water  capacity  (amount  of 
water  the  Humidifier  will  hold  at  one  time)  is  4.5  gallons.  
(3 FULL Jugs).

          

       

          

       

FILTER CARE

Rev. F 6/08 

2084256

Rev. F 6/08 

2084256

Figure 5

The presence of water flow in the Water Show Window indicates 
the circulation of water to the Filter. 

(Figure 5)

1.

  Clean  and  dry  Humidifier  thoroughly  per  the  Cleaning  

Instructions.  Do  not  leave  any  water  in  the  Unit  when  stor

-

ing.

2.

   Dispose  of  the  Evaporative  Filter  Pad.  Do  not  store  used 

 

Evaporative Filter Pad in the Humidifier. 

3.

  Place Humidifier back into its carton and store in a cool dry 

place.

OFF-SEASON STORAGE

NOTE:

 The Humidifier will only turn on when the Humidistat is set to 

a high enough setting or when the room humidity is low enough.

Figure 6

The  Filter  inside  your  Humidifier  plays  a  very  important  part  in 

its operation. In order to maintain peak performance, it is highly 

 

recommended to 

use only LASKO REPLACEMENT FILTERS

. Some 

imitation  filters  do  not  comply  with  Lasko’s  quality  standards,  
resulting in decreased performance of your Humidifier.

CAUTION: To  prevent  electric  shock,  always  turn  Power  
Control Knob to OFF position and unplug before servicing.

1. 

  To replace the Evaporative Filter Pad, remove the Jug and Upper 

Housing from the Base. 

Be careful not to let excess water from 

pump spill onto furniture or flooring.

2. 

  Remove Evaporative Filter Pad Holder from Base and inspect 

Small Water Drip Holes for any blockage. 

(Figure 7) 

Figure 7

3.

  To open the Filter Holder apply outward pressure to the two 

snaps and it will hinge open. Remove used Filter from Holder 
and discard. 

(Figure 8) 

Figure 8

4.

  Insert new Filter into Holder, snap closed, and reinstall Holder 

into Base. 

(Figure 7)

 The Filter will only fit into the Holder one 

way. Make sure the Rounded side of the Filter Holder is facing 
outward. Replace Upper Housing, then Water Jug into Base.

5.

  To increase the life of your Filter Pad turn 

Filter around (so the bottom of Filter is now 
at the top). 

6.

  Filter life may be extended by cleaning the 

Filter in a 20% vinegar solution. To clean 
Filter, mix one part undiluted vinegar with 
four parts warm tap water. Soak the Filter in this solution for 
20 minutes, rinse Filter thoroughly with warm water to remove 
vinegar odor.

CLEANING

DO NOT FLATTEN, SqUEEzE OR TWIST FILTER WHEN CLEANING

7.

  Discoloration  of  the  Evaporative  Pad  is  normal  after 

 

extended use. The discoloration is caused by mineral deposits 
in the water, and the degree of discoloration will vary depend-
ing upon the amount of mineral content in the water. When 
the Filter surface area is thoroughly discolored, or you notice  
reduced  water  usage,  it  is  a  good  indicator  that  the  Filter 
Pad  needs  to  be  replaced. 

The  Evaporative  Pad  should  be  

replaced at least once every season.

The Replacement Filter to be used in this unit is:

The Lasko Replacement Evaporative Pad Model THF 8 

(Available separately)

Humidistat 

Knob

GREEN Hu

-

midistat 

Light

Filter Pad Holder

Base

Drip Holes

Snaps

Evaporative Filter Pad

Figure 3

Water Capacity of Unit is 4.5 Gallons

Carry Handle

Stopper Lever

Quick Fill / 

Quick Empty 

Spout

Figure 4

Power Knob

RED Power

 

Light

1.

  Regular  cleaning  is  necessary  to  ensure  proper  and  

efficient operation. The frequency of cleaning depends on the 
amount of impurities which may be found in the water or how 
often the Humidifier is in operation. 

In either instance, it is 

recommended that the Humidifier be cleaned at least once 
a week.

NOTE: The bottom of the Jug may 
be  unscrewed  for  easy  cleaning. 

(Figure 9)

CAUTION: Make sure bottom of 
jug  is  securely  fastened  to  Jug  
before reinstalling into Base.

2.

 

TO DESCALE BASE AND JUG:

 

Mix one part undiluted white 
vinegar with four parts warm 
tap  water.  Let  vinegar  solu-
tion stand for 20 minutes then 
wipe away any scale buildup 
using a soft brush or cloth. 

Do 

not  use  soap  or  detergents 
and  never  use  an  abrasive 
cleaner.

3.   TO DISINFECT BASE AND JUG:

 Fill Jug with 1 teaspoon of 

chlorine bleach and 1 gallon of water. Let solution stand for 
20 minutes. Carefully empty Jug and rinse well with water until 
bleach smell is gone.

4.

  Commercial “Descalers” and “Bacteriostats” are available at 

your local home improvement center.

5.

  Do not operate Humidifier when there is still cleaner in the 

water.

FILLING and OPERATION

(Jug Holds 1-1/2 Gallons)

(Base Holds 3 Gallons)

Figure 9

6.

  Turn Power 

ON

 to desired speed. 

(Figure 4)

 

- For  fast  humidification  of  a  large  room  or  house,  

approximately 9 gallon per day.*

 

- For normal operation. 

 

- For quiet, night time operation or after desired moisture 

level is reached.

 

* Calculations based  on ambient room  conditions of 70° F  
  and 30% relative humidity in a room of average insulation.

NOTE:

 Power Light and Fan are on only when the Humidistat is 

turned to a high enough moisture setting.

7.

  To  set  Humidistat  to  desired  level  turn  Knob  towards  HIGH 

until the power is ON. After the room has reached a comfort

-

able humidity level, turn the Humidistat Knob slowly towards 

LOW until the fan shuts off and the Green Light turns on, the  
Humidifier  will  automatically  restart  when  humidity  falls  
below this setting. 

(Figure 6)

Reviews: