3 9
•
Control unit:
This control unit displays actual rotor speed values. When the rotor stops, the
unit displays a total number of running hours "th". To display a daily number of
running hours, just press the button "S". To reset this daily number, just press
the button "S" once to display a total number of running hours "th" and then
press it again and hold for total resetting. This control unit is protected by two
fuses: 7,5 A – installed just by the unit and 4 A – installed inside.
•
Right function of NOSTRESS system:
The speed regulator reduces material feeding upon contingent overloading.
The chipping wheel speed is set by the manufacturer to 1525 rpm to turn the
loading rolls off and to 1550 rpm to turn the rolls on again. Actual rotor speed
values are displayed on the control unit.
•
Speed sensor:
This encapsulated sensor in fitted on a holder keeping its distance of 2 mm
from the cam lobe. In the rear part of the sensor sleeve there is an orange
LED installed flashing in case of proper sensing.
Set-up (respectively check-up) of the speed sensor
should be done at machine standstill only.
Summary of Contents for LS 150 D
Page 1: ...OPERATING INSTRUCTIONS CHIPPER LS 150 D LS 150 DW Version 06 2010...
Page 5: ...5 EC Conformity Declaration...
Page 6: ...6...
Page 7: ...7...