Lasita Maja Exeter 2, Manual

Page: 33 / 37

The vertical position of the Fold&Slide sashes relative to one another and the size of the shadow gap
between the sashes can be adjusted at the hinges.
Hinge
Adjustment
range
Neutral position ± 0 on
base plate scale distance between screws
20/50 -5 to +1.5 0 5.5 mm
20/35* -5 to +1.5 0 5.5 mm
* Adjusting plate turned through 180°
Hinge in neutral position
Distance between screws
5,5 mm
ATTENTION
Installation, operating and maintenance instructions
Always make the adjustments at the set screws
1
and
2
one by one!
If you undo all screws at once, this could damage the sash hinge!
Aligning the Fold&Slide sash vertically by turning the set screw
1
To align the Fold&Slide sashes vertically, proceed as follows:
„
Slightly loosen the two screws
1a
so that the hinge and sash 1 can move relative to one another.
„
Adjust the vertical position of the sliding panel by turning the set screw
1
.
„
Tighten the two screws
1a
again.
4
You can adjust the vertical position of the Fold&Slide sashes relative to one another and also the
shadow gap between the sashes when installed by turning the set screws at the hinge (see fi gure
"Adjustment of the hinge" on page
5 ):
Adjusting the sash hinges