Manual: RS 400 G US
6 / 9
Revision Dec-10
Adjustable mirror mounts
RS-800RGY, RS 1000/2300 RGB: Loosen setscrews, then adjust with X/Y adjustable screws. Make
sure beam is centered on scanner mirrors. Adjust Z-screw
simultaneously Tighten setscrews.
When combining beams (RGY/RGB laser), first make sure
the beams are (roughly) on the same spot on the
mirrors/dichros. Then use a test pattern (e.g. rectangle) to
do fine adjustment. For adjustments, always turn output
power down (if possible).
Troubleshooting
Problem
Possible reason
Damaged part
Replacement
No power
Fuse blown
Fuse
09-00-3001-01
Power supply defective
+-24V
16-03-0039-00
Music mode not working
Microphone defective
Microphone
16-03-0001-00
Control board defective
Control board
26-2A-LT12V2-00
Potentiometer defective
Potentiometer
04-03-0104-01
CPU defective
IC
00-89C516RD-00
X and/or Y axis no deflection
Scanner defective
Galvo
15-01-2215-00
CPU defective
IC
00-89C516RD-00
Control board defective
Control PCB
26-2A-LT12V2-00
Power supply defective
+-24V
16-03-0039-00
Scanner driver board defective
Scanner driver board
26-2A-6800A-00
Laser dark or dim
Lenses / mirrors dirty
Clean with alcohol
Laser diode defective
Laser diode
Inquire
Control board defective
Control board
26-2A-LT12V2-00
Configuration / wrong mode
Check configuration (see
paragraph control panel)
No output
Configuration / wrong mode
Check configuration (see
paragraph control panel)
Control board defective
Control PCB
26-2A-LT12V2-00
Power supply defective
+-24V
16-03-0039-00
Display board defective
Display
26-2A-YX2012DI-00
Pins 4 and 17 of the ILDA signal not
connected
See below
Laser does not switch to ILDA mode:
•
The interface does not connect pins 4 and 17 (Interlock) of the ILDA signal. See interface manual
•
The cable does not connect pins 4 and 17. Use a cable that connects pins 4 and 17.
•
Use an adapter, that connects pins 4 and 17.
ILDA signal
Pin out of the standard ILDA signal:
1 Scanner X+
-5V..+5V
14 X-
+5V..-5V
2 Scanner Y+
-5V..+5V
15 Y-
+5V..-5V
3 Intensity/B
0V..+2.5V
16 Intensity/Blanking-
0..-2.5V
4 Interlock A
17 Interlock B
5 Red+
0..+2.5V
18 Red-
0..-2.5V
6 Green+
0..+2.5V
19 Green-
0..-2.5V
7 Blue+
0..+2.5V
20 Blue-
0..-2.5V
8 – 12 Not used
23-24 Not used
13 S5V, max. 20 mA
25 GND Signal ground
Please note
This device has left our premises in absolutely perfect condition. In order to maintain this condition
and to ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions
and warning notes written in this user manual.
